ford-falcon-fg-ute-xr-xr6-2-1-2-catback-kit-inc-hotdog-dual-tailpipe

FORD FALCON FG UTE XR XR6 2 1/2" CATBACK KIT INC HOTDOG & DUAL TAILPIPE

FORD FALCON FG UTE XR XR6 2 1/2" CATBACK KIT INC HOTDOG & DUAL TAILPIPE (SKU: ford-falcon-fg-ute-xr-xr6-2-1-2-catback-kit-inc-hotdog-dual-tailpipe).

DistributorExhaust Systems Australia

Category: Mufflers and resonators

RRP $290.00 AUD
Confirmed on order
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
FORD FALCON FG UTE XR XR6 2 1/2" CATBACK KIT INC HOTDOG & DUAL TAILPIPE product image

Part specs

SKU
ford-falcon-fg-ute-xr-xr6-2-1-2-catback-kit-inc-hotdog-dual-tailpipe
Supplier
Exhaust Systems Australia
Category
Mufflers and resonators
Stock status
Confirmed on order

Where a rear-can swap only touches the back, the Exhaust Systems Australia FORD-FALCON-FG-UTE-XR-XR6-2-1-2-CATBACK-KIT-INC-HOTDOG-DUAL-TAILPIPE is the full cat-back kit for the FG Falcon ute (XR / XR6) — a 2in run that carries a hotdog resonator mid-system and finishes through a dual tailpipe.

What's in the cat-back kit?

This is a complete cat-back: it replaces the pipework from the catalytic converter rearwards, so it's a system change rather than a single muffler. The kit bundles a hotdog — a compact straight-through resonator — to settle drone without choking flow, and exits through a dual tailpipe at the back of the ute. That gives a more finished result than a rear-only can, because the bore and silencing are matched along the whole run.

What does the hotdog resonator change?

A hotdog is a small straight-through resonator built to knock the edge off cruise frequencies while staying free-flowing. On the FG ute it tunes the note so the system can open up without a constant highway boom — the trade most owners want from a cat-back over a louder straight pipe. At 2in the kit is sized for the standard six, keeping gas speed sensible on a daily-driven tray.

Is it road legal in NSW?

This is a cat-back, so it starts behind the catalytic converter and leaves the factory emissions hardware in place — the cat itself isn't part of the kit. Confirm with the workshop what your FG ute needs to stay registrable in NSW, since requirements depend on your exact build.

Fitting the cat-back at our Illawarra workshop

Oak Flats Muffler Men supplies and fits cat-back kits like this in-house. We line up the hotdog and dual tailpipe to the factory hangers, check tray and bar clearance, and confirm the 2in run sits right before final mounting. It's listed to fit the FG Falcon ute (XR/XR6) at $290 AUD; we verify your exact fitment rather than relying on the catalogue alone.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Does the kit include the catalytic converter?
No — it's a cat-back, so it starts behind the cat and leaves the factory emissions hardware in place. Confirm NSW registrability for your build with the workshop.
What's the hotdog for?
The hotdog is a compact straight-through resonator that trims cruise drone while keeping the system free-flowing.
Will it fit my FG Falcon ute?
It's listed to fit the FG Falcon ute in XR and XR6 form. Confirm your exact variant with the workshop before ordering.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.