K-RPM16025

Redback Dual 3" Catback Exhaust with Rear Muffler for Holden Commodore Ute VT-VZ

Redback Dual 3" Catback Exhaust with Rear Muffler.

BrandRedbackRedback Exhausts

Category: Mufflers and resonators

RRP $1170.56 AUD
Order in
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Redback Dual 3" Catback Exhaust with Rear Muffler for Holden Commodore Ute VT-VZ (1997 - 2007) product image

Part specs

SKU
K-RPM16025
Supplier
Redback Exhausts
Category
Mufflers and resonators
Vehicle fitment
holden
Stock status
Order in

The Redback K-RPM16025 is a dual 3in cat-back with a rear muffler, listed to fit the Holden Commodore Ute VT–VZ from 1997 to 2007. The retained rear muffler is the defining choice here: it keeps the twin 3in ute liveable rather than letting it run open.

What does keeping the rear muffler give you?

On a twin 3in cat-back the rear muffler is the volume control. The K-RPM16025 keeps that box so the ute gains the flow of dual 3in while the note stays under control for daily and work use — the muffler soaks up the volume that an open rear would otherwise let through. The 3in sizing suits a bigger or worked Commodore.

How is the ute routing different?

A cat-back runs from the cat back to the tailpipe, and on the VT–VZ Ute that pipework is shaped around the tray and chassis rather than a sedan floor. This system is listed specifically for the ute body, so the dual 3in run and rear muffler are routed for the tray. The factory cat stays in place.

Will it suit my VT–VZ Commodore Ute?

It's listed to fit the Holden Commodore Ute across VT to VZ, 1997 to 2007. With several series in that span, the workshop will check your exact build against the correct ute section lengths and hanger points before ordering.

What does fitting involve in the Illawarra?

Oak Flats Muffler Men supplies and fits the K-RPM16025 in-house across the Illawarra. We align the cat-back joint, run both 3in banks to the rear muffler, set the hangers and check clearance past the tray, chassis and rear bumper.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Does the K-RPM16025 have a rear muffler?
Yes. It's the with-muffler version, which keeps the twin 3in ute more liveable than an open rear.
Is it for the ute or the sedan?
It's listed for the VT–VZ Commodore Ute, with routing shaped for the tray and chassis. Confirm your build with the workshop.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.