KB9015-XCMX

Mitsubishi Pajero NT (4M41T) 3.2L Turbo Diesel Dec 2008 to Oct 2011 - 3 Inch Turbo Back

Pacemaker Australia Mitsubishi Pajero NT (4M41T) 3.2L Turbo Diesel Dec 2008 to Oct 2011 - 3 Inch Turbo Back Exhaust System with Cat and Centre.

BrandPacemaker

Category: Mufflers and resonators

RRP $2112.06 AUD
Confirmed on order
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Mitsubishi Pajero NT (4M41T) 3.2L Turbo Diesel Dec 2008 to Oct 2011 - 3 Inch Turbo Back Exhaust System with Cat and Centre Muffler product image

Part specs

SKU
KB9015-XCMX
Supplier
Pacemaker
Category
Mufflers and resonators
Vehicle fitment
Mitsubishi NT
Stock status
Confirmed on order

Cat kept, a single centre muffler, nothing at the rear — the Pacemaker KB9015-XCMX is the cat-retaining 3in turbo-back for the Mitsubishi Pajero NT (4M41T 3.2L turbo-diesel, December 2008 to October 2011) that leans on one mid-system muffler to keep the note civil.

What does a lone centre muffler change?

With the catalytic converter retained and a single centre muffler doing the silencing, this build sits between the bare straight-through option and the twin-silencer version. The muffler quietens by absorption and reflection inside its chamber, taking the hard edge off the 4M41T's note without a rear can behind it. It is the sensible middle for an NT owner who wants a fuller note than stock that still behaves on the highway, without going as hushed as a muffler-plus-resonator setup.

Does the KB9015-XCMX stay road registrable?

Yes in principle: it keeps the factory catalytic converter, so the emissions hardware the NT Pajero left the showroom with stays in the line, which is the deciding factor for a diesel's road compliance. We list this part to fit rather than to certify your individual vehicle, so confirm the exact build and any NSW requirements with the workshop before fitting.

What is the 3in turbo-back span?

The run replaces the exhaust from the turbo outlet back to the tailpipe in one 3in bore — a longer section than a cat-back, and on a 3.2L turbo-diesel the part that tends to open up most. Held to a consistent diameter the whole length, it keeps the bore even from the turbo to the tip on the NT body.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men supplies and fits Pacemaker turbo-back systems in-house across the Illawarra. It is listed to fit the NT Pajero (December 2008 to October 2011) and is priced at $2,112.06 AUD, confirmed at order. Send your build and we will confirm the muffler clearance, hangers and the cat join before booking the bay.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

How does the centre-muffler build differ from the resonator one?
The muffler gives broad absorption and a calmer overall note; a resonator instead targets cruise drone specifically. This build relies on the centre muffler, with nothing at the rear.
Does the KB9015-XCMX keep the catalytic converter?
Yes. This is a with-cat build, so the factory cat stays in place — the key emissions consideration for road registration on a diesel. Confirm NSW requirements with the workshop.
Will it fit my NT Pajero?
It is listed to fit the Mitsubishi Pajero NT (4M41T 3.2L turbo-diesel), December 2008 to October 2011. Confirm your exact variant with the workshop before ordering.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.