KB9200-XXXX

Mitsubishi Challenger PB/PC 2.5L (4D56T) 2009-2015 Manual - Single 3" Exhaust System

Mitsubishi Challenger PB/PC 2.5L (4D56T) 2009-2015 Manual - Single 3" Exhaust System with no Mufflers (SKU: KB9200-XXXX), $1304.37

BrandPacemaker

Category: Mufflers and resonators

RRP $1304.37 AUD
Confirmed on order
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Mitsubishi Challenger PB/PC 2.5L (4D56T) 2009-2015 Manual - Single 3" Exhaust System with no Mufflers product image

Part specs

SKU
KB9200-XXXX
Supplier
Pacemaker
Category
Mufflers and resonators
Vehicle fitment
Mitsubishi PB
Stock status
Confirmed on order

The Pacemaker KB9200-XXXX is the no-muffler cat-back build of this single 3in system, listed to fit the Mitsubishi Challenger PB/PC 2.5L 4D56T manual (2009–2015). The empty, silencer-free run is the headline: with nothing fitted to absorb or tune the note, it is the loudest and most open of the family.

What does a no-muffler cat-back sound like?

With neither a muffler nor a resonator in the run, this cat-back system is left open behind the converter. There is no chambered absorption and no frequency tuning, so the 2.5L 4D56T diesel comes through hard and unfiltered. It suits owners chasing the freest flow and the loudest note, and it reads very differently from the muffler and resonator builds in the same family.

What does cat-back mean on the Challenger?

Cat-back means the system replaces everything from the catalytic converter rearward, leaving the converter in place. The single 3in pipework behind the converter is swapped — here with no silencer in the run — while the emissions hardware at the front stays as fitted.

Will it suit my Mitsubishi Challenger?

It is listed to fit the Mitsubishi Challenger PB/PC 2.5L 4D56T manual from 2009 to 2015. Confirm your exact build, transmission and year with the workshop before ordering — and bear in mind the no-muffler note is the loudest of the family when you choose it.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men supplies and fits this Pacemaker cat-back system in-house across the Illawarra. We confirm the 3in run clears the underbody cleanly to the rear, then book the bay once your build is verified. The KB9200-XXXX RRP is published.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Is the KB9200-XXXX the loudest of this Challenger family?
Yes — with no muffler or resonator fitted, the run is left open, giving the hardest and most free-flowing note.
Does it keep the catalytic converter?
Yes — it's a cat-back system, so it replaces only what's behind the converter and leaves the converter in place.
Will it fit my manual Challenger?
It's listed to fit the Mitsubishi Challenger PB/PC 2.5L 4D56T manual from 2009–2015. Confirm your build with the workshop first.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.