STR130

Redback Twin 2.5" Centre Mufflers For Holden Commodore VT VX VY VZ 5.7

Redback Twin 2.5" Centre Mufflers.7 for selected vehicle applications.

BrandRedbackSWD

Category: Mufflers and resonators

RRP $451.00 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Redback Twin 2.5" Centre Mufflers For Holden Commodore VT VX VY VZ 5.7 product image

Part specs

Tube Size
063mm (2 1/2")
Vehicle Make
Holden
Coating
Standard Heat-Proof Paint
Exit
Twin Out

The Redback STR130 is a twin centre muffler set built around 2in pipe, listed to fit the Holden Commodore VT, VX, VY and VZ. The twin layout is the standout — a pair of centre mufflers for the dual-exhaust Commodore rather than a single silencer.

Why a twin centre muffler set?

The STR130 is a twin set — two centre mufflers, one per side, for a Commodore running a dual exhaust. A pair of centre silencers gives each bank its own quietening path through the middle of the car, which is why the set is supplied as a matched twin rather than one muffler. On the VT–VZ V8 cars a twin centre setup is the natural match for the dual rear arrangement.

What the 2in pipe size suits

This set is built around 2in pipe. A 2in muffler is sized toward a more modest or near-stock flow rather than a big-bore performance build — it suits keeping gas speed up across a twin layout where two pipes share the work. As chambered mufflers, the pair quietens by absorption and reflection and leans toward a settled note. The supplier publishes no sound figures, so we attach none.

Will it suit my Commodore?

It's listed to fit the Holden Commodore VT, VX, VY and VZ. That run spans several drivetrains, so confirm your exact model and that your car runs a dual centre setup with the workshop before ordering. We check the twin layout against the actual car so the set matches.

Fitting a twin set at Oak Flats

Oak Flats Muffler Men supplies and fits the STR130 across the Illawarra. Fitting a twin set means setting both centre mufflers level and symmetrical — we check the hangers and joints on each side, balance the run, and clear the mufflers around the floor and tailshaft. We'll inspect the front and rear sections on the hoist at the same time.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Why is the STR130 a twin set?
It's two centre mufflers, one per side, for a dual-exhaust Commodore — each bank gets its own quietening path through the middle of the car.
What pipe size is it?
It's built around 2in pipe, sized toward a more modest or near-stock flow across the twin layout. We publish no sound figures.
Does it fit any VT-VZ Commodore?
It's listed across VT, VX, VY and VZ. Confirm your exact model and that your car runs a dual centre setup with us before ordering.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.