STR133

Redback 2.5" Centre Exhaust with Mufflers for Holden Commodore VT-VZ U

Redback 2.5" Centre Exhaust with Mufflers.

BrandRedbackSWD

Category: Mufflers and resonators

RRP $484.00 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Redback 2.5" Centre Exhaust with Mufflers for Holden Commodore VT-VZ U product image

Part specs

Exit
Twin Out
Coating
Standard Heat-Proof Paint
Vehicle Make
Holden
Tube Size
063mm (2 1/2")

The Redback STR133 is a centre exhaust assembly carrying two mufflers, listed to fit the Holden Commodore VT–VZ. Because it runs a pair of mufflers in the one centre section, it does more of the sound control in the middle of the car than a single-muffler section would.

Why two mufflers in the centre section?

The STR133 is built with twin mufflers in the centre run. A pair of chambered silencers in series gives the system more surface to absorb and reflect sound, which is the honest reason a manufacturer uses two rather than one — more quietening capacity in the same span of the car. It's a centre assembly, so it sits between the front pipe and the rear of the system on the Commodore.

What is a centre muffler assembly?

This is the mid-section of the exhaust, shaped to route under the Commodore floor and carry the gas rearward through its mufflers. Replacing it is the usual fix when the original centre run has rusted, split, or started to resonate. Twin chambered mufflers lean toward a subdued, settled note rather than a loud one; the supplier publishes no sound data and we quote none.

Does it fit my VT to VZ Commodore?

It's listed to fit the Holden Commodore across the VT–VZ range. That's a long model run with several drivetrains, so confirm your exact body and engine with the workshop so we match the right centre assembly. Listed-to-fit data should always be checked against the actual car.

What's involved in fitting at Oak Flats?

Oak Flats Muffler Men fits the STR133 across the Illawarra. We unbolt or cut out the old centre run, check the hangers and the joints to the front and rear sections, and set the twin-muffler assembly so it hangs clear of the floor and tailshaft. While it's up we'll flag any neighbouring rust before it becomes the next job.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

How many mufflers are in the STR133?
Two — it's a centre assembly built with a pair of mufflers in series for more quietening across the middle of the car.
Will the STR133 fit any VT-VZ Commodore?
It's listed to fit the VT-VZ range. Send us your exact model and engine so we confirm the centre section matches before ordering.
Is this the whole exhaust?
No, it's the centre section. It works with your existing front and rear sections unless those also need replacing.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.