STR249D

Redback 2.5" Rear Muffler for Ford Falcon BA & BF Ute (10/2002 - 12/2014)

Redback 2.5" Rear Muffler.

BrandRedbackRedback Exhausts

Category: Mufflers and resonators

RRP $330.00 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Redback 2.5" Rear Muffler for Ford Falcon  BA & BF Ute (10/2002 - 12/2014) product image

Part specs

SKU
STR249D
Supplier
Redback Exhausts
Category
Mufflers and resonators
Vehicle fitment
ford
Stock status
In stock at supplier

The Redback STR249D is a rear muffler in a 2.5in bore — the silencer that sits at the back of the run and does the final quietening before the tailpipe. It's listed to fit the Ford Falcon BA and BF ute built from 10/2002 to 12/2014.

Where does a rear muffler sit, and what does it do?

The rear muffler is the last box in the line, nearest the tailpipe, so it carries most of the responsibility for the note you actually hear at the back of the ute. This is a chambered silencer: it quietens by reflecting and absorbing pulses inside the body rather than just letting gas blow through. As a single rear unit it's the piece you change when the back box is the part that's tired, blowing or out of spec — not a full system.

Why a 2.5in bore on the Falcon ute?

At 2.5in this is the larger of the common Falcon pipe sizes, matched to the six and V8 ute pipework rather than a smaller stock pipe. The bore sets how much it flows; keeping the rear muffler at 2.5in means it mates cleanly to a 2.5in run without stepping the pipe up or down at the back of the car.

Will it suit my BA or BF Falcon ute?

It's listed to fit the Ford Falcon BA and BF ute across the 10/2002–12/2014 window. Because that span covers a long production run and several variants, confirm your exact build, the rest of your pipework and any prior exhaust work with the workshop before ordering.

What does fitting involve at our Illawarra workshop?

Oak Flats Muffler Men supplies and fits this rear muffler in-house across the Illawarra. We mate it to your existing 2.5in pipework, set the tailpipe position and check the hangers so it sits clear of the tray and tow gear. Bring the ute in and we'll confirm the fit and book the bay.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Is the STR249D the front or rear box?
It's the rear muffler — the silencer nearest the tailpipe that does the final quietening on the Falcon ute.
What bore is it built for?
2.5in, the larger of the common Falcon pipe sizes, so it mates to a 2.5in rear run.
Which Falcons does it fit?
The BA and BF ute from 10/2002 to 12/2014. Confirm your exact build with Oak Flats Muffler Men before ordering.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.