STR613

Redback 3" Rear Muffler for Holden Commodore VE/VF - Passenger Side

Redback 3" Rear Muffler.

BrandRedbackSWD

Category: Mufflers and resonators

RRP $247.99 AUD
In stock at supplier
Afterpay, Zip Pay & Zip Money available
Afterpay acceptedZip accepted — Zip Pay and Zip Money
Redback 3" Rear Muffler for Holden Commodore VE/VF - Passenger Side product image

Part specs

Coating
Standard Heat-Proof Paint
Tube Size
076mm (3")
Vehicle Make
Holden
Material Type
409 Stainless Steel

STR613 is the passenger-side rear muffler for the Holden Commodore VE and VF. Supplied by Redback, it's the handed rear silencer for the passenger half of a dual rear setup, sold individually rather than as a matched pair.

Why does the side matter?

A dual-exit VE-VF Commodore runs a handed muffler on each side, with the inlet, outlet and mounts set for that half of the car. The STR613 is the passenger-side unit. The routing and hanger geometry are mirrored left to right, so fitting the wrong-side muffler leaves the pipework and tailpipe out of line. If both rear boxes are due, you'd combine it with the driver-side equivalent.

What job does the rear muffler do?

This is the rear silencer at the back of the run, doing the final quietening before the gas leaves the tailpipe. A chambered muffler works by absorbing and reflecting sound to keep the exit note controlled. Sold as a single passenger-side unit, it's the part to reach for when one side is rusted, blown or damaged — a targeted swap rather than a whole-system change.

Will it suit my VE or VF Commodore?

It's listed to fit the passenger's side of the Holden Commodore VE and VF. Since that spans two related generations with different bodies and exit setups, confirm your exact model, body and tailpipe arrangement with the workshop so we match the right side and spec before ordering.

What does fitting involve in the Illawarra?

Oak Flats Muffler Men supplies and fits this rear muffler in-house across the Illawarra. We take out the old passenger-side box, fit the STR613, and check hangers and tailpipe alignment so it sits true. Bring your Commodore in and we'll confirm the side and book the bay.

Stocked and fitted by Oak Flats Muffler Men, the Illawarra exhaust and 4x4 specialist in Oak Flats, NSW.

Common questions

Which side is the STR613?
The passenger's side. The driver-side equivalent is a separate part.
Can I buy just one side?
Yes — this is a single passenger-side rear muffler, sold individually.
Will it fit my Commodore?
It's listed to fit the passenger's side of the VE and VF Commodore. Confirm your exact model and exit layout with Oak Flats Muffler Men before ordering.

Fitment support across the Illawarra

Fitment checks near you across 18 Illawarra suburbs, from Oak Flats and Shellharbour to Wollongong and Kiama.
Show nearby fitment areasCollapse section

Book the right exhaust job without guessing.

Send the vehicle make, model, year, engine, current issue, desired sound or performance goal, and clear photos of the existing exhaust where available.